Trakmark-FG

Trakmark-FG

Full Gloss Water based Kerb Marking Enamel

Category: Water Based Paints Uses:
  • TRAKMARK - FG is formulated for line marking on all outdoor traffic kerbs
Benefits:
  • It gives better gloss as compare to synthetic enamel
  • It requires no thinner to thin the paint, only water is required Dries within 10 min unlike synthetic enamel which takes 60 min minimum to dry.
Application:
  • Air and surface temperature should be above 10 C.
  • Humidity prolongs drying time so ensure that it is not more than 85%.
  • Do not apply when the temperature is falling or rain is imminent.
  • TRAKMARK - FG is suitable for application by airless spray, roller or brush.
  • Stir well before use.
  • Using airless spray equipment, use spray tips and between 2000 and 2500 psi (138 to 172 bar) pressure.
  • One coat at the recommended wet film thickness should be sufficient under normal conditions, depending on the texture of the surface.
  • Equipment can be cleaned using clean tap water and detergent if necessary.
Aftercare:
  • Not normally necessary but TRAKMARK -FG can be cleaned using a brush and detergent solution.
Colours Available:
  • White
  • Yellow
  • Red
  • Blue
  • Green
  • Black
  • Recommended Film Thickness : 0.150 mm (wet)
  • Coverage : Approx. 6m2 / litre
  • Specific Gravity (SG) : 1.05
  • Application Temp. : Minimum 10oC
  • Application Humidity : Maximum 85%
  • Drying Time @25oC : 5-10 min(touch dry)
  • "TRAKMARK - FG is supplied in 4, 20 ltr resealable containers."
  • "Store in a dry, well-ventilated place.Protect from frost."
  • TRAKMARK - FG will be unuseable if it has been allowed to freeze.
  • The recommended storage temperature is 27”ĘC. Shelf life is 12 months under normal conditions.